Aeodynamic bodykits part installation

method of installation and procedures

Preparation of parts for installation

rear lip installation

REAR skirt installation

SIDE skirt installation steps

SIDE skirt installation steps

FRONT skirt lip instllation steps procedure

FRONT skirt lip instllation steps procedure

Before installation, it is advisable to always test proper fit of the parts by bringing parts into its intended position to understand the process of the whole installation. Meanwhile marking the outline of the parts for guideline during installation using removable marker if necessary.

Using a fine sand paper, remove all excess paint and other containment from contact surfaces if necessary. Work thoroughly, and clean all contact surfaces on parts with a Universal cleaner.

Start applying PU adhesive glue ( For parts fixation design with adhesive glue installation) or removing double sided tape ( For parts with tape installation) in the mark position and let parts to dry or set preferably over night before any washing.

Install all necessary bracket / screws that is required to hold the parts in place.

Avoid washing the water for the next 24 hour for the tape / glue to fully cure.

Back to top